Soprema AL + G 200 S4 - Sand/Foil

The

AL + G 200 S4 is installed on concrete as a vapour barrier membrane in accordance with the Technical Rules for the Planning and Execution of Waterproofing with Polymer Bitumen and Bitumen Membranes (abc der Bitumenbahnen vdd e.V.), Flat Roof Guidelines (ZvdH e.V.) and DIN 18531 et seq. If the vapour barrier membrane is to be used as a "temporary temporary seal" at the same time, the homogeneously welded seam formations must be manufactured and tested with particular care. We would like to point out that a temporary temporary waterproofing has lower performance characteristics than a correspondingly dimensioned waterproofing. The installation is carried out by welding.

Processing

The bitumen vapour barrier membrane is partially or fully welded to the substrate with a suitable burner parallel to each other and with a transverse seam set. The track can also be laid loose if necessary; in this case, only the longitudinal and transverse seam overlaps must be welded over the entire surface. The longitudinal seam cover is at least 0.08 m, the transverse seam cover is at least 0.10 m.

Bitumen membranes have reduced elasticity at low temperatures and should therefore not be used at temperatures below 5°C. Otherwise, material-related cracks cannot be ruled out.

Processing recommendations:

• Use of a roll puller and winding core to exert uniform contact pressure during welding
• Corner bevel cuts at T-joints

Storage, transport and durability

The rolls must be stored upright on a flat surface. The pallets must not be stored on top of each other! Protect from sunlight, heat and moisture (rain, snow, etc.) for the duration of storage. During the cold season, the material must be stored at >+5°C for at least 12 hours before processing.

Disposal

Waste from polymer bitumen and bitumen membranes (European Waste Catalogue – EWC number 17 03 02 "Bitumen mixtures") is disposed of in accordance with the current version of the Circular Economy and Waste Act.

When

handling the open flame, the regulations of the building and professional association must be observed. We recommend using a winding core to exert uniform contact pressure during processing.

Approval / Standards

Identification Number Certification Body: 1119

EN 13970

Delivery Form

• Article Description 00154177 R0030   AL + G 200 S4 - Sand/Foil
• Top Course: Modified Bitumen

Underside: Modified Bitumen

• Equipment Top: Fine Sand

Underside: Foil

• Carrier 1 Aluminum Composite Carrier
• Carrier 2 Glass Fabric (200 g/m²)
• Delivery form 1.00 m x 5.00 m;

Thickness: 4.00 mm

approx. 30.00 kg