Fixit 435 EPS Base Plaster Combi light

Fixit AG

Description

Fixit 435 is used for bonding polystyrene thermal insulation panels as well as for embedding the Fixit reinforcement mesh in fine mesh.

More Over

Mix with the continuous mixer or agitator. To activate the adhesion promoter, let it rest for at least 5 minutes and then mix again and process with the usual tools.

Gluing:

  • The substrate must be clean, dry and load-bearing.
  • In the edge/strip method with center pat. The contact surface of the adhesive must be  at least 40%.

Embedding:

  • The polystyrene sheets must be perfectly glued and firmly jointed. Open panel joints must be closed with XPS or EPS 35 kg/m3 wedges. The surface of the rigid foam insulation must be sanded flat and dusted.
  • The Fixit Reinforcement Mesh Fine Mesh must be completely embedded. The joints must overlap by at least 10 cm. For mineral top plasters, the surface must be roughened according to the grain size of the top plaster.

  • Aftercare In extreme weather conditions, measures are required to protect the fresh combi plaster. (shading, humidification, driving rain protection, etc.)

Special notes

  • : Do not use below +5 °C (air and ground). The glued panels may only be mechanically stressed after three days. 

Technical Information

Composition

  • Binders: Cement, Hydrated White Lime
  • Aggregates: Limestone sands with a grain size of 0 – 1.0 mm
  • Additives: Water retainers, adhesion promoters, hydrophobic agents
  • Consumption: 4kg/m²
  • Processing time 60 - 90 min.
  • Layer thickness: Embedding at least 3 mm

Downloads

Used in Projects